Removing The Stock Backplate Cover; Removing The Pre-Installed I/0 Shield - ekwb EK-Quantum Vector FE RTX 3080 User Manual

Gpu water block

Table of Contents

M3 x 12 DIN 7991

BACKPLATE COVER

STEP 2

M3 x 5 SCREW

STEP 3

STEP 2

REMOVING THE STOCK BACKPLATE COVER

After removing the backplate, unscrew the three (3) backplate

cover screws as shown in the picture, using the enclosed Allen Key

(2 mm), and take off the backplate cover. Save the screws and cover

for later use.

For this Step, you will need:

Allen Key 2.0 mm

STEP 3

Unscrew the three (3) M3X5 screws using Phillips head-screwdriver

and remove the I/O shield (as shown in the picture). Save the screws

and I/O shield for the later use!

For this Step, you will need:

Phillips Head Screwdriver

- 10 -

Table of Contents

Do you have a question about the EK-Quantum Vector FE RTX 3080 and is the answer not in the manual?