5.14 Store Loop Adapter Interrupt Flag Byte
This table describes the bits of the store loop adapter interrupt flag
byte.
This byte is updated by the software interrupt service routine when
a level 7 hardware interrupt occurs.
+------------------------------------------------------------------------+
¦ Table
5-8. Store Loop Adapter Interrupt Flag Byte
+------------------------------------------------------------------------¦
¦ Bit
¦ Definition
+-------+----------------------------------------------------------------¦
¦ Bit 7 ¦ 1 =
The level 7 interrupt is not from the store loop adapter. ¦
+-------+----------------------------------------------------------------¦
¦ Bit 6 ¦ 1 =
An interrupt occurred when not expected (Bit 0 = 0).
+-------+----------------------------------------------------------------¦
¦ Bit 5 ¦ 1 =
More than one interrupt occurred when only one was
¦
¦
expected (Bit 0 = 1).
+-------+----------------------------------------------------------------¦
¦ Bit 4 ¦ Not used, always zero (0).
+-------+----------------------------------------------------------------¦
¦ Bit 3 ¦ Not used, always zero (0).
+-------+----------------------------------------------------------------¦
¦ Bit 2 ¦ Not used, always zero (0).
+-------+----------------------------------------------------------------¦
¦ Bit 1 ¦ 1 =
A store loop adapter level 7 hardware interrupt has
¦
¦
occurred.
+-------+----------------------------------------------------------------¦
¦ Bit 0 ¦ 1 =
A store loop adapter level 7 hardware interrupt is
¦
¦
expected.
+------------------------------------------------------------------------+
4684 Store Loop Adapter/A
Store Loop Adapter Interrupt Flag Byte
¦ Copyright IBM Corp. 1991
5.14 - 1
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦