Graco ChemSafe 515 Series Instructions - Parts Manual page 4

Warnings
EQUIPMENT MISUSE EQUIPMENT EQUIPMENT
Misuse can cause death or serious injury.
• Do not operate the unit when fatigued or under the influence of drugs or alcohol.
• Do not exceed the maximum working pressure or temperature rating of the lowest rated
system component. See Technical
• Use fluids and solvents that are compatible with equipment wetted parts. See Technical
in all equipment manuals. Read fluid and solvent manufacturer's warnings. For complete
information about your material, request MSDS from distributor or retailer.
• Do not leave the work area while equipment is energized or under pressure.
• Turn off all equipment and follow the Pressure
• Check equipment daily. Repair or replace worn or damaged parts immediately with genuine
manufacturer's replacement parts only.
• Do not alter or modify equipment. Alterations or modifications may void agency approvals
and create safety hazards.
• Make sure all equipment is rated and approved for the environment in which you are using it.
• Use equipment only for its intended purpose. Call your distributor for information.
• Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.
• Do not kink or over bend hoses or use hoses to pull equipment.
• Keep children and animals away from work area.
• Comply with all applicable safety regulations.
THERMAL EXPANSION THERMAL THERMAL
Fluids subjected to heat in confined spaces, including hoses, can create a rapid rise in pressure
due to the thermal expansion. Over-pressurization can result in equipment rupture and serious
injury.
• Open a valve to relieve the fluid expansion during heating.
• Replace hoses proactively at regular intervals based on your operating conditions.
PLASTIC PARTS
PLASTIC PLASTIC
Many solvents can degrade plastic parts and cause them to fail, which could cause serious
injury or property damage.
• Use only compatible water-based solvents to clean plastic structural or pressure-containing
parts.
• See Technical
solvent manufacturer's MSDSs and recommendations.
4
Springer Pumps, LLC
Telford, PA 18969
WARNING
WARNING WARNING
MISUSE MISUSE HAZARD HAZARD HAZARD
Technical Data Technical
EXPANSION EXPANSION HAZARD HAZARD HAZARD
PARTS CLEANING CLEANING SOLVENT SOLVENT HAZARD
PARTS CLEANING SOLVENT
Technical Data Technical Data in this and all other equipment instruction manuals. Read fluid and Data
Tel: 866-777-6060 / Int'l: 215-949-2900
Fax: 866-777-6383 / Int'l: 215-721-1296
Data in all equipment manuals. Data
Pressure Relief Relief Procedure Procedure when equipment is not in use.
Pressure Relief Procedure
HAZARD
HAZARD
Technical Data Data
Technical Data
334794B
shop.springerpumps.com
info@springerpumps.com