Table of Contents
Advertisement
Controls and Functions
Front Panel
A
｜
○
P P P P O O O O W W W W E E E E R R R R
a
a. Power on/off switch
b. TX switch
Press this switch to capture image and send. When the Video Through
Function is activated (AVT command is ON), pressing this switch will
enable output of the video signal connected to the Video Input to be
bypassed to the video output so that you can monitor the video image. Press
this switch again to capture the image and then transmit it through the radio
equipment.
When the Video Through Function is de-activated (AVT command is OFF),
pressing this switch will automatically capture the video image and then
transmit it through the radio equipment.
Refer to : Operation -- Digital Image Communication at page 20 for details.
c. 2 color LED
Illuminated red
Blinking red
Illuminated Green
Unlit
d. Status LED (STA LED)
It is lit when unsent data remains in the memory.
It is lit with orange color when Video Through Faction is activated in digital
video communication mode.
It is not lit when Video Through Function is deactivated by the dedicated
command (AVT_OFF) though PC. Because, TX switch activates a sequential
faction of capturing and transmission.
It is also lit with orange color when unsent data is remained in the memory in
the data transmission mode.
F
A
S
T
R
A
I D
O
M
R
D
9
8
0
0
Min
T T T T X X X X
B B B B U U U U S S S S
S S S S T T T T A A A A
S S S S P P P P
c
d e
b
The unit is in the transmit mode
In the digital communication mode, it blinks while
the header information is being sent. (approximately
one (1) second)
The unit is in the receive mode
The unit is in the receive standby mode or in the
analog voice receive mode.
O
D
E
M
1 1 1 1 0 0 0 0 1 1 1 1 0 0 0 0 1 1 1 1
Max
M M M M O O O O D D D D E E E E
C C C C H H H H A A A A N N N N
O O O O V V V V E E E E R R R R
h
f
i
g
6
M M M M I I I I C C C C
j
Advertisement
Table of Contents
