Digital Image Communication; Receive; Transmit - AOR ARD9800 Operating Manual

To send binary data, add [FE] (hexadecimal) to a header and footer with the data.
FE BBBBBBBBBBBBBBBB FE
BBBBBBBBBBBBBBB
FE
Note: If you need to insert the data [FE] in hexadecimal in the middle of the
text, convert it into two (2) bytes of hexadecimal data.
FE
If you need to insert the data [FD] in hexadecimal in the middle of the text,
convert it into two (2) bytes of hexadecimal data.
FD
Note: The maximum data length is 2046 bytes per packet.
At the receive side, the data will be automatically decoded and displayed on
the PC screen. If the [ALF] command is set ON, the LF (line feed) code will
be added at the end of received data.

Digital Image Communication

Receive

When valid digital image data is received, it will be decoded and output as a
video image from the VIDEO OUT connector.
If received data is missing during a transmission, that portion will be displayed
as invalid (like noise).

Transmit

Push the TX switch to send the image.
(When pin - 4 of the microphone connector is grounded, the ARD9800 starts
sending the image.)
Note: When the Video Through Function is activated (AVT command is ON=
default), pressing the TX switch will enable output of the video signal connected
to the Video Input to also be sent to the video output, so that you can monitor the
video image. Press the TX switch again to capture the image and then transmit it
through the radio equipment.
When the Video Through Function is de-activated (AVT command is OFF),
pressing the TX switch will automatically capture the video image and then
transmit it through the radio equipment.
The Progress indicator will display on the monitor during image transmission.
Binary data
ID as a binary data
FDD8
FDDD
20