For lower voltage battery operation, set the internal jumper terminal for battery
operation, and then connect external batteries.
Warning: If you have changed the internal jumper for low-voltage battery
operation, battery voltage must be within the range of 5.6 ~ 6.5 VDC. DO
NOT apply 12.0 V or severe damage will result, and the warranty will be void!
Note: There is no low battery voltage detector built-into the ARD9800.
r. FG Screw
Frame ground
Top Panel
s. Internal Speaker
Internal View
(PCB design subject
to changes.)
t. Factory setting jumper
Must be set between 2-3. (Do not change this setting at any time.)
s
10