Interfacing The Ard9800; Connection To A Radio - AOR ARD9800 Operating Manual

Interfacing the ARD9800

Connection to a Radio

Before using your ARD9800, you will first need to wire the cable between your radio
equipment and the ARD9800.
For your convenience, an 8-pin of a microphone connector for the ARD9800 is included.
You will need to prepare, however, your own microphone connector for your radio
equipment.
Below are the pin assignments of the 8-pin RADIO connector on the rear panel of the
ARD9800.
Pin number Signal
1
2
3
4
5
6
7
8
Note:
ARD9800 connector, or RF feedback will result.
Both a microphone plug and a cable for your radio transceiver are required to be
prepared at the user side.
MIC GND
MIC OUT
PTT (H)
PTT (L)
NC
NC
GND
NC
MIC GND and GND must not be connected together in the
Details
Microphone ground
Microphone Output
PTT (Push To Talk) Output (H level)
PTT (Push To Talk) Output (Low level)
No connection
No connection
Ground
No connection
12