Related Manuals for Verderflex Vantage 5000
Summary of Contents for Verderflex Vantage 5000
- Page 1 Peristaltic Cased Tube Pump Software Upgrade Vantage 5000 Version 1.1v-09/2019 Print-No.
- Page 2 Vantage 5000 Version 1.1v-09/2019 Print-No. 01 Software Upgrade 1.1v-09.2019 2 | Page Vantage 5000...
-
Page 3: Table Of Contents
Table of contents Vantage 5000 Software Upgrade Backup the Jobs File/Settings File Formatting the USB drive Vantage 5000 Software Update Process 1.3.1 Introduction 1.3.2 Equipment 1.3.3 Glossary 1.3.4 Procedure System Reset Procedure Vantage 5000 Screen Calibration 1.5.1 Introduction 1.5.2 Screen Calibration Procedure 1.5.3 Resetting the Screen Calibration... -
Page 4: Vantage 5000 Software Upgrade
1. Vantage 5000 Software Upgrade This document helps to upgrade the software on your Vantage 5000 pump. CAUTION Upgrading to a new software may result in losing the jobs file/settings file A software upgrade will delete all existing information on the pump. -
Page 5: Backup The Jobs File/Settings File
Verder strongly recommend backing up job files/system settings. Switch the Vantage 5000 pump OFF and then ON again using the ON/OFF switch on the back of the pump. Insert the USB into the USB port on the back of the pump. -
Page 6: Formatting The Usb Drive
10. Make sure firmware file is named ‘Jupiter.bin’. (capital J) Any other name will result in the pump not updating (e.g ‘Jupiter.bin.bin’). 11. Safely remove USB stick from computer. Figure 4 Format the USB Drive Software Upgrade 1.1v-09.2019 6 | Page Vantage 5000... -
Page 7: Glossary
Wait for the red LED to switch OFF and the green LED to switch ON. 1.3.2 Equipment Note For updating the software on a Vantage 5000 pump the following will be necessary: This can take up to a minute to complete the update process. •... -
Page 8: System Reset Procedure
Users will be prompted for screen calibration when: and should only be used when necessary. It will not be possible • the software has been updated (g 1.3 Vantage 5000 to recover previously saved job information once the system Software Update Process) reset has been carried out. -
Page 9: Screen Calibration Procedure
When prompted to perform a system reset, do not press any of the buttons on the screen. Turn OFF the Vantage 5000 pump using the ON/OFF switch on the back of the pump. When the pump is turned back ON, the screen calibration routine will start again and the screen can now be recalibrated. -
Page 10: Restore The Jobs File/Settings File
When the jobs file/settings file is imported, a pop-up no- tification will confirm that job files have been imported as Figure 11c and 11e. Press “p” to complete the restore pro- cess. Figure 11 Restore the Jobs File/Settings File Software Upgrade 1.1v-09.2019 10 | Page Vantage 5000...
Need help?
Do you have a question about the Vantage 5000 and is the answer not in the manual?
Questions and answers