Downloading Results To The Software Application Suite - Abbott SoToxa Oral Fluid User Manual

8 . M A I N M E N U | 9. D O W N L O A D I N G R E S U LT S
Step 6: Re-screw the card cover into place.
Please note that if the battery is too low, then the warning message shown below will appear when you start to export the data. Either charge
the analyser or simply connect to the mains before starting the export again.
9.

Downloading results to the Software Application Suite

If the Software Application Suite is being used, test data stored on the SoToxa™ Mobile Analyser can be downloaded by connecting the
analyser to a PC on to which the Software Application Suite has been installed. The Software Application Suite can be used to store and view
test data and allows generation of reports from the stored data. The Software Application Suite is not compatible with Apple Macintosh/
Mac operating systems. For details of the PC operating systems which are compatible with the Software Application Suite, please refer to the
Software Application Suite user guide which can be found on the Software Application Suite CD-ROM.
The analyser must not be connected to the Software Application Suite while a test is in progress.
Step 1: Ensure the Software Application Suite is installed on the PC. For installation instructions, refer to the Software Application Suite user guide on
the Software Application Suite CD-ROM.
Step 2: When the analyser is on the main menu screen, physically connect the analyser to the PC via the micro USB cable provided. The USB
connector is beneath the rubber flap at the top of the analyser. See section 2.1 SoToxa™ Mobile Analyser at a glance.
Step 3: Launch the Software Application Suite on the PC by double clicking the Software Application Suite icon.
Step 4: The analyser will appear in the analyser main menu of the Software Application Suite. Click on this to connect to the analyser.
Step 5: Once connected to the Software Application Suite, the analyser will display the following screen:
Step 6: Follow the Software Application Suite instructions. Do not disconnect the analyser during data transfer.
Step 7: It is recommended that results stored on the analyser are regularly downloaded to the Software Application Suite to ensure that data is backed
up. Frequency of downloads will be dependent on testing volumes. To find out more about how to use the Software Application Suite, refer to
the Software Application Suite user guide which can be found on the Software Application Suite CD-ROM.
28 | EN
Step 5
S O T O X A™ M O B I L E A N A LY S E R | U S E R G U I D E