Alarms - Tecnodom Attila Series User And Maintenance Manual

EN | Blast chillers | User and maintenance manual
Stop
Display
When the time cycle is selected the display shows the time (in hours and minutes) or the records of the core
probe if the probe cycle is selected.
The upper point of the second display shows the selection in case of negative process.
Keys
Set, Up
Set
to go automatically to the negative and positive probe cycle process.
Press Set key for 4 sec the control panel is in stand-by.
Press Up or Down
erwise set +/- for the time cycle.
If the buzzer is on, pressing Down
Press Start/Stop
Start
Display
The display shows the remaining time (in hours and minutes), when the time cycle is selected or the records of
the core probe if the probe cycle is selected.
If the presence of door is on (PI=I) and the contact is not well closed, on the display appears "dr" which shows
that the door is open.
Keys
Pressing the "SET"
time cycle, in order to reach the cycle temperature, if it is in conservation modality.
Pressing Up
If the buzzer is on, pressing Down
Press Start/Stop
ATTENTION
At the end of the positive process phase, the conservation program is set automatically at the temperature of 0 to +3°C.
At the end of the negative process phase, the conservation program is set automatically at the temperature of -22 to -25°C.
In order to respect the chilling and freezing time provided by law, while a cycle is in progress, it is
strongly advised against opening the door of the device.

6.3 ALARMS

The existing alarms are those related to the probes. They are shown only when it is required the view of the
relative probe. "Er" Generic or internal error of the probes.
"Er" generic error or inside the probe.
"ErI" room probe error.
"Er2" core probe error.
If one program is in progress and an error is generated, the cycle passes to time process even if the error con-
tinues to be on. See also chapter "8 MESSAGES OF ERROR AND SOLUTIONS" Pag. 45.
42
Down keys permit to enter the cycle setting.
to set automatically time cycle if previously was selected the core probe cycle, oth-
to turn it off.
to start the cycle.
key the display shows the time passed from the starting of the cycle or the time of the
, the temperature recorded by the room probe is shown. This data lasts 5 seconds.
to turn it off.
to start the cycle.