Starting The Blast Chiller - Tecnodom Attila Series User And Maintenance Manual

6. If the power supply cable is damaged, it must be substituted by the manufacturer or by its
technical assistance service or however by a person with similar qualifications, so as to avoid
all risks. No liability whatsoever can be accepted if the above instructions in not complied with.
In order to prevent any risks if the the compressor supplied is damaged, these must be replaced
7.
by qualified technician.Installation must be carried out only by qualified technicians according to the
regulation in force. No liability whatsoever can be accepted if the above instructions in not complied with.
WARNING
Any operation of ordinary and extraordinary maintenance of the equipment must be done disconnecting
the electric power supply. This maintenance must be done by qualified technician.
The plug has to be always connected to a fixed outlet. It is strictly forbidden to connect the equipment
plug to an extension cord or an adapter.

2.2 STARTING THE BLAST CHILLER

ATTENTION
The first start up must be carried out by qualified staff.
Before switching on the blast chiller, be sure that:
• Your hands must be dry.
• The surface of the blast chiller must be dry.
• The floor and the electrical socket must be dry.
Furthermore, be sure that:
• The build in condensing unit blast chiller must be carried only in upright position. If it had leaned, we
recommend to wait at least 8 hours before proceeding with the start so that the oil will flow in all the
components, lubricating them again.
For the temperature setting make reference to the corresponding chart about product categories/ usage tem-
perature, in addition For the working parameters regulation refer to the user instructions of the control panel
enclosed to this current manual.
Once the blast chiller is connected with the power cable (see the previous paragraph), proceed
powering it with the switch closing.
For the built in unit, before plugging it in, verify that the selector is open in 0, OFF or green position. Insert the
socket and then turn off the switch. Before placing inside the food to be chilled or frozen, it is necessary to clean
the chamber of the appliance (see chapter about cleaning) and afterwards it will be required to chill in advance
the chamber before starting the positive or negative processes.
For regulating the functioning parameters consult the instructions for the instrument panel enclosed to the
current manual.
Blast chillers | User and maintenance manual | EN
31