4.3.3 Enlarged display of integral power consumption.
In case electric energy is being displayed by the general measurement display, an electric-energy display
is changed to a normal display (5 digits of integers), and an enlarged display (2 digits integer + below decimal
point, 3 digits). A change is performed by SET . After an enlarged display, if a switch is not operated for
10 minutes, it returns to the usual display automatically.
<Caution > If it continues pushing SET 3 seconds or more, it will become the setting mode 1.
A(Y) display
W display Wh display
V(RY) display
Normal display
4.3.4 Setting value check
A voltage range (primary voltage), a current range (primary current), and an alarm-output set point are
checked. Check is RESET/SHIFT and - are pushed simultaneously and performed.
The change of a set point is carries out by + and - .
original measurement display. And, if a switch is not operated for 10 seconds after a set point check,
it will return to the original measurement display automatically.
A(Y) display
V(RY) display
W display
Measurement display
11
Note(
) It is not displayed if there is no option.
No operation 10 minute
SET
SET
No operation
10 minute
RESET/SHIFT
+
-
DISPLAY
Wh display
-
+
Time interval,
Contact delay
time
11
(
)
Watt-hour enlarged display
Enlarged display
DISPLAY is pushed in case it returns to the
Primary voltage
Factor display
Set point check
Voltage range (primary voltage),
Rated voltage
Alarm factor,
-
Upper limit
(lower limit)
value
+
Return method
11
(
)
19
Input-rating voltage display
(At 3φ3W,1φ2W)
-
Current range
(primary
current)
+
SFLC-211-185
+
-