Hayward AquaRite + Owner's Manual page 16

Filtration
1
OK
4
Setting the Pump Type
The unit comes preset to power a single speed pump on/off via the power socket on the base of the unit. Maximum load is 7A.
1
OK
6
3
OK
Hayward variable
4
SPA 5
6
Lighting
(50 Watts Max Load - One {1} LED Only) (Turning on the light will reduce maximum T-Cell chlorine output by ~ ⅓)
1
OK
1
Lighting.
2
Manual mode (ON/OFF).
3
Automatic mode: Starts up according to the
time slots used to set the lighting start and end
times. The time slots can be configured with the
following frequencies: daily, every 2 days, every
Page 16
2
5
maximum temperature, above which the filtration times will be determined by the time schedules,
and the minimum temperature, below which filtration will be reduced to five minutes, the minimum
operation period. Between these two temperatures, the filtration times will increase linearly.
The antifreeze mode can be activated to turn the filtration on if the water temperature falls below
2°C.
Setting Time Schedules: When setting the time periods for any schedule, use the up and down
arrows to highlight the schedule to be adjusted and then press either the + or - button to enter the
schedule (will change to a lighter highlight) and adjust the on time hour position. Use the up arrow to
move to the right and the down arrow to move left in the schedule.
When the schedule is set, press the 'OK' button once to fully highlight the schedule again and then
OK
using the up and down arrows select another schedule.
Once all of the schedules are set to your liking press the 'OK' button twice to save.
2
Enter the Service menu from the configuration
menu.
Enter the password:
+ - OK
Enter the Pump type menu.
Select the type of pump.
The default pump type is "standard" (single-
speed).
2
OK
3 days, every 4 days, every 5 days, weekly, every
2 weeks, every 3 weeks, every 4 weeks.
4
LED light: If you are using a coloured LED light,
go to the menu to configure it.
5
Colour selection: This menu allows you to
change the colours manually and, according
USE ONLY HAYWARD
3
1
Filtration modes.
2
Manual: Allows the filtration process to be turned on and off manually.
3
Filter cleaning: This mode is used to backwash the filter.
4
Automatic: In this mode, filtration is turned on according to the start
and end times set in the time schedules. The time schedules always
operate on a daily basis.
5 Smart: This mode is based on the automatic mode, with its three
filtration intervals, but the filtration times are adjusted according to the
temperature. This is done by setting two temperature parameters: the
3 4
OK
N.B: TriStar VS, Maxflo VS, and Super II ECO VS pumps with revision 4.0 or
higher software can have the AQR+ select between speeds V1, V2, or V3 on
the motor drive. When the AQR+ is configured to control a Hayward Variable
Speed Pump, the power socket is disabled and the pump needs to be permantly
powered from a regular GPO.
No pump with a FASCO imPower variable speed motor is to be powered
via the power socket on the base of the AQR+. Doing so will cause
potential damage to the control relay which will not be covered by
warranty.
3
OK
®
GENUINE REPLACEMENT PARTS
5
OK
+
Filter pump
-
OK
4
OK
to the type of LED light, program the pulse
length required to cycle through the colours and
programs (by default, 0.5 s, maximum 10 s).
Press the 'OK' button with the "Next Program" tab
highlighted to change between the colours. Refer
to light manufacturer's manual for pulse duration.
6
5