Hayward AquaRite + Owner's Manual page 15

Setting the Salt Chlorination
1
OK
7
SPA
SPA
8
SPA: SPA settings activation. (The installation of the Hayward Spa Flow Switch
Upgrade Kit is required to use this feature)
9
Boost (Super Chlorination): Filtration and continuous production of chlorine
for 24 hours (maximum production level).
Automatic return to the filtration and production mode programmed after the 24
hours.
Salt Concentration
1
OK
SPA
Calibrate T-Cell Temperature Probe
1
OK
Assigning Relays
1
OK
1 Enter System Settings menu from the Main Menu
2 Enter the Service Menu from the configuration
menu
+ -
3 Enter the password:
4 Select the Relay Config. tab
2 3
8 9
SPA
2 3
2 3
OK
2 3
OK
5 Filtration: Select the relay that the Filter Pump is
connected to. Relay "Filter" is intended for a Filter
Pump
Lighting: Select the relay that the lights are wired
to. Relay "Light" is intended for Lighting (powered
®
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
4
OK
OK
10
3
OK
4
5
6
7
10
During the boost period, redox (ORP) control (option) can be deactivated.
Note: the device can only control the operation of the filtration pump if the
pump is plugged into the "Filter Pump" outlet socket on the base of the unit.
1
4
2
3
SPA
4
2
Temperature probe calibration: Allows you to set the probes to 1 point.
3
Without removing the probe from the water, use the + / - keys to adjust the
reading to your reference value (thermometer). The same conditions should
apply for measurements.
4
OK
Relay config.
+
Filter pump
-
Extra settings
6
5
OK
Enter the Service menu from the configuration
menu
Enter the password:
Choose the T-Cell model corresponding to the one
that is installed.
Electrolysis: Electrolysis function programming.
Level: Chlorine production (gr/h) required.
Adjustable between 0 - 30 g/hr. Refer to page 10
for cell specifications
Salt concentration measurement.
Enter in the Salinity menu, use Enter to measure
the salt concentration for polarity 1, then for
polarity 2. This measurement can only be done
manually. It will have to be taken periodically.
Adjustment: Once the measurement has been
taken, you can adjust the salt level manually.
Display: Once the salt concentration has been
measured, it is displayed on the salt chlorination
(electrolysis) screen and the main screen.
5
Relay config. Relay config.
Heating Heating
No
Filtration Filter Filtration
Lighting Lighting
Light
output 12Vac) but can be assigned to AUX 3 as a
dry contact control.
Heating: Select which relay the heater is wired to.
Relay AUX 4 is intended for a heater.
6
OK
6
OK
AUX 4
Filter
Light
Page 15