Cable Gland Installation - Hayward AquaRite + Owner's Manual

Cable Gland Installation

In order to ensure watertight wire connections to the PCB through the AquaRite+ housing, wire cables are to be secured with the black
cable glands supplied. The cable gland supplied with the pH Kit is for the Peristaltic Pump connection.
Cable
Gland
1.
Insert the cable into the domed end of the
gland and pull through.
3.
Tighten gland with a spanner whilst still
holding the nut to secure the gland in place.
Note: Use the gland location holes in the bottom of the unit before the sides to ensure all cables are pointing downward.
Wiring the Peristaltic Pump
Once the Cable Gland installation is complete, the Perisaltic Pump can be wired to its corresponding relay. If the wires aren't already
stripped back, do so. Screw in the brown wire to terminal 3 and the blue wire to terminal 4, as labelled on page 7.
Fitting the pH Chip Set
Installing the chip set updates the firmware of the AquaRite+, unlocking the ability to control the pH level of the pool or spa when used in
conjuction with the pH probe and perisaltic pump. Insert the pH Chip Set into the terminal on the AquaRite+ PCB as shown below, ensuring
the pins are facing to the left. After this, access to the PCB is no longer required and the Dead Front Panel can be screwed back on. Ensure
that the gasket is fitted correctly before securing the Dead Front Panel and then reinstall the display module.
Page 8
ELECTRICAL CONTINUED
Tighten
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
®
Nut
Mounting
Frame
2.
Hold the nut against the hole on the inside
of the mounting frame. Push the cable and
gland into the hole whilst simultaneously
rotating to screw the nut on to the thread.
Tighten
4.
Pull the cord through the gland until the
intended input point can be reached.
Secure and seal the cord in place by
fastening the domed cap with a spanner
until firm.
Pins Facing To The Left
Insert pH Chip Set Here