Turning The Display Off; Adjusting The Volume; Selecting Layouts And Input Sources - Planar UltraRes X Series User Manual

Table of Contents

17.5 Turning the Display Off

With the power on, press the OFF button on the remote or the power button on the keypad to

put the LCD panel in a standby mode. To turn off power completely, turn the AC switch to "O" or

disconnect the AC power cord from the power outlet.

Note: The display may automatically turn off the backlight or enter standby mode if no signal is

present for a certain period of time. See the description of the Power Saving Mode setting on

page 46 for more information.

1. Using the remote, press the vol + or vol - to increase or decrease the volume. You can

also use the Up and Down keys on the remote and keypad to increase or decrease the

volume.

2. Press the mute button to temporarily turn off all sound. To restore the sound, press the

mute button again.

Note: The analog audio out is variable. S/PDIF is fixed.

With Planar MediaPlex Plus Processing, you can show one source at a time or multiple sources

simultaneously. Multiple layout options are available and can be selected from the Inputs and

Views Menu (see page 36). Once a layout has been designated, you can assign sources to

each of the zones in the layout. The selection of sources must be made one at a time by

assigning a current zone. To select the current zone, you can navigate through the on-screen

menu (see page 36). Alternatively, you can use the remote or keypad as described next.

Remote

Press the Zone 1, Zone 2, Zone 3, or Zone 4 buttons on the remote. After selecting the desired

zone, you can press the source button (DP, HDMI 1, HDMI 2, HDMI 3, HDMI 4, or OPS). This

action will also select the active audio source.

For example, to change Zone 3 to OPS, press the Zone 3 button and then press the OPS

button.

Keypad

Press the SRC button. The input source will be toggled in the following order: HDMI 1, HDMI 2,

HDMI 3, HDMI 4, DP, OPS).

Note: Sources will toggle through the current zone, or last zone to be modified. Current zones

can only be re-assigned in the on-screen menu.

Planar UltraRes X Series User Manual

020-1396-00A

Page | 36

Table of Contents