Table of Contents
Advertisement
Mounting & Installation
Caution!
ƒ
Installation and connection should only be carried out by a quali ed person.
ƒ
Only quali ed electricians or authorised service sta are permitted to open the controller.
ƒ
If the controller is used in a way not speci ed by the manufacturer, its safety may be impaired.
ƒ
Prior to setting the controller, it is necessary to complete all required settings described in the section.
ƒ
Do not use sharp tools to push any button
ƒ
WARNING!
Isolate mains supply before commencing installation and ensure the unit is properly earthed
The IMC is supplied with its own surface mounting box, which can be mounted over
a single or double gang ush wall box. It should not be mounted on an unearthed
metal surface.
An immersion heater must have its own radial circuit.
This should be protected by a 16 Amp RCBO.
Immersion Controller
5
Advertisement
Table of Contents
Need help?
Do you have a question about the IMC and is the answer not in the manual?
Questions and answers
Hi i forgot pin to my controller is any chance to reset some how ?
To reset the PIN on an EPH Controls IMC controller, follow these steps to perform a factory reset, which will remove the PIN:
1. Press the button until ‘P01’ flashes on the screen.
2. Use the arrow buttons to scroll to ‘P05’.
3. Press the button again. ‘No’ and ‘rst’ will appear on the screen.
4. Use the arrow buttons to scroll to ‘YES’.
5. Press the button to confirm.
The device will restart and return to its factory default settings, including removal of the current PIN.
This answer is automatically generated