Safety Information - KegLand BrewZilla 35L Instruction Sheet

WARNING IMPORTANT INFORMATION!
1. Please read this ENTIRE instruction sheet before using the BrewZilla unit. If
you are unsure about any part of using this brewery please refer to the
YouTube videos that we have made or contact your local distributor.
2. If the BrewZilla is damaged in any way do not use it. Contact your local
distributor.
3. NEVER turn on the pump without attaching the recirculation arm shown in
step 4 of the instructions. If you do not fit this arm you could be at risk of
spraying hot wort into the air causing injury.
4. NEVER turn on the pump without first attaching the recirculation arm first.
Also do not run the pump dry for extended periods. This can damage the
pump.
5. NEVER lift the BrewZilla when it is completely full, we strongly urge you to
use a hose to fill your unit. Use the pump or ball valve to transfer your wort.
Lifting a heavy / hot BrewZilla may result in serious injury. The new
secondary handle is for cleaning purposes only.
6. If at any stage the recirculation arm is not fitted and/or needs to be removed
always ensure the ball valve is turned off (see instructions under the
heading
7. NEVER clear a blocked pump by spraying water down the recirculation arm
or directly into the pump inlet.
8. Do not boil dry. Do not turn on the elements if there is less than 4 liters of
liquid in the boiler. This is the minimum fill level.
9. Use only the recommended cleaners and sanitiser products listed in the
recommended accessories section (p.20-22). Using chemicals not tested or
recommended on the BrewZilla can result in permanent damage and void
warranty.
If you require further assistance with chemical compatibility
please contact
Page 2 of 29
http://www.KegLand.com.au Last Updated 12/01/2021 09:01 AM