Storage - Intimidator GC 1K Owner's Manual

Storage
Notice:
 Do not store the vehicle in direct sunlight.
Preparation for Storage:
1. Thoroughly clean the entire vehicle.
2. Run the engine for five minutes to warm the oil. If you do not intend to use
a fuel stabilizer, run the engine outdoors until the motor stops from lack of
fuel. If the vehicle will be stored with fuel in the tank, fill the tank completely
and add an appropriate fuel stabilizer.
3. Change the engine oil and oil filter.
4. Remove the spark plugs and pour approximately 1 oz. of engine oil into the
cylinder(s). Replace the plugs and crank the engine several times with the
ignition key to distribute the oil evenly.
5. Place boards under the tire to keep moisture away from the rubber.
6. Lubricate throttle cable.
7. Remove the battery and store it where it will not be exposed to direct
sunlight, moisture, or freezing temperatures.
8. Tie a plastic bag over the exhaust pipe, CVT intake, and the CVT exhaust
to prevent moisture or small animals from taking up residence.
9. Put a cover over the vehicle to keep dust and dirt from collecting.
Removal from Storage:
1. Remove the cover
2. Remove the plastic bags from the exhaust pipe, CVT intake, and the CVT
exhaust.
3. Clean the battery terminals, charge the battery if necessary, and install it
into the vehicle.
4. Check the spark plugs for tightness and that the wires are connected
snugly.
5. Fill the fuel tank with fresh fuel.
6. Check each point listed in the "Pre-Ride Checklist" at the end of this
manual.
7. Lubricate any fixtures as required.
55