Figure 5 Alarm Output Connectors - Kahn Optisure Remote User Manual

Optisure Remote User's Manual
DANGER
Electric
Shock Risk
For each output:
1. Strip back the wire for the common (black) connection to the
connector way for the
0.25" (6mm) wire and clamp into the screw block
not overtighten the screw.
2. Strip back the wire for the
connector way for the
0.25" (6mm) wire and clamp into the screw block
not overtighten the screw.
3. Strip back the wire for the
way for the
wire and clamp into the screw block
the screw.
4. Repeat operations 1 to 3 for the
appropriate colored wires.
5. Locate the terminal block over the connector labelled
the terminal block firmly into the connector.
Kahn Instruments
WARNING: Alarm leads MUST be potential free when wiring
Alarm Output Connectors
Figure 5
FAULT alarm contact set, exposing approximately
N/O
FAULT alarm contact set, exposing approximately
N/C
(e.g. blue) connection to the
FAULT alarm contact set, exposing approximately 0.25" (6mm)
to the connector block.
COM
(e.g. green) connection to the
terminal way. Do
N/O
N/C terminal way. Do not overtighten
PROCESS alarm contact set, using
ALARMS
INSTALLATION
COM
terminal way. Do
N/O
N/C
connector
and push
9