Rhino-Rack 43175 Instructions

Important: Please read these instructions carefully prior to installation.
Please refer to your fi tting instruction to ensure that the alloy tray is installed correctly.
Check the contents of this kit before commencing fi tment and report any discrepancies.
Maximum Lashing Capacity: 225kg/ 496Lbs per set.

Recommendations:

Use only non stretch fastening ropes or straps. Do not overload your Rhino-Rack Pioneer Platform/ Tray or Tradie Tray
and roof bars. Check your vehicle's roof carrying capacity. Exercise caution when driving off road as vehicle roof height
has been increased. Be aware of increased sensitivity to cross winds.
- Regularly check strap condition for any signs of abrasion. Immediately replace. Do not use a strap that is damaged.
- Do not overload roof capacity. Always evenly distribute load.
- Remove load/ roof racks when putting vehicle through an automatic car wash.
Caution:
The handling characteristics of the vehicle change when you transport a load on the roof. For safety reasons, we
recommend exercising extreme care when transporting large wind-resisting loads; special consideration must be
taken into account when negotiating corners and under braking.

Note for Dealers and Fitters:

It is your responsibility to ensure instructions are given to the end user or client.
Rhino-Rack
3 Pike Street, Rydalmere,
NSW 2116, Australia.
(Ph) (02) 9638 4744
(Fax) (02) 9638 4822
These instructions remain the property of RhinoRack Australia Pty. Ltd. and may not be used or changed for any other purpose than intended.
Pioneer Pickup Kit 43175
Important Information
Document No: R728
Prepared By: Kayle Everett
Authorised By: Chris Murty
CONTROLLED
Fit time: 15min
Issue No: 03
Issue Date: 16/05/16
Page 1 of 2