Rhino-Rack Rhino 2500 series Installation Instructions Manual

Rhino-Rack Rhino 2500 series Installation Instructions Manual

For euro crossbar
Hide thumbs Also See for Rhino 2500 series:

Advertisement

Quick Links

Please refer to your fitting instruction to ensure that the roof racks are installed in the correct locations.
Important:
Check the contents of kit before commencing fitment and report any discrepancies.
Place these instructions in the vehicle's glove box after installation is complete.
IMPORTANT Care Instruction: Wash and clean the vehicle roof prior to fitting the Roof racks.
Maximum carrying capacity: 75kg (165lbs) evenly distributed over crossbars. Please refer to your vehicle
Recommendations:
It is essential that all bolt connections be checked after driving a short distance when you first install your crossbars. Bolt con-
nections should be checked again at regular intervals (probably once a week is enough, depending on road conditions, usage,
loads and distances travelled). You should also check the crossbars each time they are refitted. Make sure to fasten your load
securely. Please ensure that all loads are evenly distributed and that the centre of gravity is kept as low as possible.
Use only non-stretch fastening ropes or straps.
Load Ratings
When these roof racks are to be used on a vehicle that is driven off sealed roads, the manufacturer maximum roof load rating (to
be found in the vehicles User Manual) should be
tract 5kg = weight of crossbar and legs), these racks, when fitted to this vehicle should have no more than 35kgs loaded on them
Caution:
The handling characteristics of the vehicle changes when you transport a load on the roof. For safety reasons we recommend
you exercise extreme care when transporting wind-resistant loads. Special consideration must be taken into account when cor-
nering and braking.Please remove crossbars when putting vehicle through an automatic car wash.
Note for Dealers and Fitters:
It is your responsibility to ensure instructions are given to the end user or client.
Rhino 2500 series for Euro Crossbar.
PLEASE READ THROUGH INSTRUCTIONS BEFORE FITTING.
manufacturers handbook and DK Specification sheet for maximum roof loading.
Always use the lower of the two figures.
halved
. For example, if the vehicles maximum roof load rating is 70kgs (sub-

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Rhino 2500 series and is the answer not in the manual?

Questions and answers

Summary of Contents for Rhino-Rack Rhino 2500 series

  • Page 1 Rhino 2500 series for Euro Crossbar. Please refer to your fitting instruction to ensure that the roof racks are installed in the correct locations. Important: Check the contents of kit before commencing fitment and report any discrepancies. Place these instructions in the vehicle’s glove box after installation is complete.
  • Page 2 Rhino 2500 series for Euro Crossbar. ü ü km/h ? kg 2 x Crossbars = 5kg When these roof racks are to be used on a vehicle that is driven off 70kg load rating 35 kg load rating sealed roads, the manufacturer...
  • Page 3 Rhino 2500 series for Euro Crossbar. Item Component Name Euro End Cap Euro Crossbar Front Cover M8 Clamp Bolt Clamp Rubber Base Pad Foot Plate Euro Crossbar Adaptor M6 x 25mm Security Screw M6 Spring Washer M6 Flat Washer M6 Square Nut Allen Key - Long Tools Required;...
  • Page 4 Rhino 2500 series for Euro Crossbar. Clip the foot plate onto the leg with the arrow facing in the correct direction IN or Out according to your vehicle listed in the DK specification sheet. Diagram shows arrow facing OUT). Foot pad must swing freely.
  • Page 5 Rhino 2500 series for Euro Crossbar. Tighten the leg security screw to 3-4N/m with the allen key provided. DO NOT OVERTIGHTEN . Press the endcaps onto the ends of the crossbars, a rubber mallet may be needed to gently tap the end caps on.
  • Page 6 Rhino 2500 series for Euro Crossbar. Wipe the roof clean before placing the assembled roof racks on. Open the doors and hook the metal strap in at the top of the door jam underneath any rubber seals that may be there. Tighten the M8 Clamp bolt TENSION THE BOLTS ON EACH SIDE OF THE VEHICLE EVENLY, DO NOT TIGHTEN ONE SIDE AT A TIME.
  • Page 7 Rhino Rack 2500 Series - DK258 FRONT VEHICLE Date Crossbar Pad / Clamp Pad / Clamp Foot plate Bar measurement HD Crossbar FRONT RIGHT FRONT LEFT arrow direction strip. Length per side. distance ( x ). Kia Venga 5dr hatch 2009- 1180mm M282 / SUB0381...
  • Page 8 300mm / 11,13/16” 750mm / 29,17/32” 50kg / 110lbs Subaru Impreza 5dr hatch 2012- 270mm / 10,5/8” 675mm / 26,37/64” 75kg / 165lbs Subaru Impreza 4dr sedan 2012- 280mm / 11,1/32” 650mm / 25,19/32” 75kg / 165lbs RHINO-RACK CARGO CARRIERS ROOF BARS...

This manual is also suitable for:

2500 series

Table of Contents