Advertisement
Important: Please read these instructions carefully prior to installation. Please refer to your fitting instruction to ensure that the roof racks
are installed in the correct location. Check the contents of kit before commencing fitment and report any discrepancies. Place these
instructions in the vehicle's glove box after installation is complete.
Recommendations:
Use only non stretch fastening ropes or straps. Do not overload your Rhino-Rack Pioneer Platform/ Tray or Tradie Tray
and roof bars. Check your vehicle's roof carrying capacity. Exercise caution when driving off road as vehicle roof height
has been increased. Be aware of increased sensitivity to cross winds.
- Regularly check strap condition for any signs of abrasion. Immediately replace. Do not use a strap that is damaged.
- Only use approved metal or high strength polyethylene jerry cans when transporting fuel.
- Always use the approved colours to identify types of fuel carried.
- Always place fuel behind the driver on the roof or towards the rear of the vehicle.
- Do not overload roof capacity. Always evenly distribute load.
- Remove jerry cans/roof racks when putting vehicle through an automatic car wash.
Caution:
The handling characteristics of the vehicle change when you transport a load on the roof. For safety reasons, we
recommend exercising extreme care when transporting large wind-resisting loads; special consideration must be
taken into account when negotiating corners and under braking.
Note for Dealers and Fitters:
It is your responsibility to ensure instructions are given to the end user or client.
Rhino-Rack
3 Pike Street, Rydalmere,
NSW 2116, Australia.
(Ph) (02) 9638 4744
(Fax) (02) 9638 4822
These instructions remain the property of RhinoRack Australia Pty. Ltd. and may not be used or changed for any other purpose than intended.
Rhino Double Horizontal Jerry Can Holder
with Locking Cable 43152
Important Information
Maximum Capacity: 45kg/ 99Lbs.
Document No: R476
Prepared By: Kayle Everett
Authorised By: Chris Murty
CONTROLLED
Fit time: 15min
Issue No: 01
Issue Date: 01/06/15
Page 1 of 2
Advertisement
Table of Contents
Related Manuals for Rhino-Rack 43152
Summary of Contents for Rhino-Rack 43152
- Page 1 Maximum Capacity: 45kg/ 99Lbs. Use only non stretch fastening ropes or straps. Do not overload your Rhino-Rack Pioneer Platform/ Tray or Tradie Tray and roof bars. Check your vehicle’s roof carrying capacity. Exercise caution when driving off road as vehicle roof height has been increased.
- Page 2 Rhino Double Horizontal Jerry Can Holder with Locking Cable 43152 Parts List Slide the four channel nuts into the openings at the front or rear of the tray. Push back into desired M8 x 16 Hex Bolt B019 position above one of the trays crossbars.
Need help?
Do you have a question about the 43152 and is the answer not in the manual?
Questions and answers