Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Clarke JetKing 2000
Summary of Contents for Clarke JetKing 2000
- Page 1 POWER WASHER OPERATING & MAINTENANCE INSTRUCTIONS 0298...
- Page 2 Thank you for purchasing this JetKing 2000 Power washer This machine is a lightweight, portable, high pressure power washer, designed for DIYuse in and around the home. It comprises an electric motor, a pump, a high pressure hose with a trigger and...
-
Page 3: Safety Precautions
SAFETY PRECAUTIONS WARNING Water at high pressure can be dangerous and may cause severe damage to persons or property if improperly used. NEVER allow anyone to operate this equipment unless they are thoroughly reliable, and completely familiar with the safety precautions. Never direct the spray jet at any person or animal. -
Page 4: Electrical Connections
ELECTRICAL CONNECTIONS WARNING: THIS MACHINE MUST BE EARTHED. This product is provided with a standard 13 amp, 230 volt (50Hz), BS 1363 plug, for connection to a standard, domestic electrical supply. Should the plug need changing at any time, ensure that a plug of identical specification is used. -
Page 5: Assembly And Preparation For Use
ASSEMBLY AND PREPARATION FOR USE. A. High Pressure Hose (2) At one end of the hose is a spigot, fitted with an O-ring. Push this end firmly into the water inlet port of the handle and lance assembly, and insert the Hose Securing Clip (Spare Parts list, item 9), ensuring it is fully home. -
Page 6: Operation
NOTE: In some areas, it may be necessary to ensure that you comply with local bylaws concerning the use of water from the mains supply, and the disposal of possibly contaminated water. Hose, worm drive clips and other accessories are readily available from all good DIY, Hardware and Garden Supplies Stores. - Page 7 IMPORTANT: NEVER run the machine ‘off load’ for long periods, (greater than 1 minute), without pulling the trigger, as damage to the pump will eventually occur. A fan or pencil spray is possible by twisting the nozzle as shown in the diagram. Pump pressure is factory set and cannot be adjusted.
-
Page 8: Care And Maintenance
On top of the foam attachment is a yellow knob with a serrated edge, which can be turned clockwise or anticlockwise to adjust the amount of detergent allowed into the water jet. Turn the knob clockwise to reduce the amount and anticlockwise to increase. -
Page 9: Troubleshooting
Insert a screwdriver into the slot provided in the centre of the fan, which is at the rear of the machine, visible through the grille. Turn the fan with the screwdriver to free the seals. Water inlet filter Located behind the inlet Hose Adapter, this filter should be removed for cleaning after every 10 hours of use (or less if water is contaminated). -
Page 10: Specifications
ACCESSORIES The accessories listed below provide the JetKing with great versatility and are available from your local branch of Machine Mart. A. 3-Piece Kit. (Code No. 050420620) comprising: Large, auto cleaning, soft bristled Rotary Brush. Drain Cleaner. Exerts a powerful water jet via its’ 8 metre flexible hose, which may also be used as a prod to remove blockages. -
Page 11: Parts List And Diagram
PARTS LIST & DIAGRAM Item Description Part No. Lance and Trigger Assy AR3560 Lance Extension AR3629 Hose Assembly AR2000420 Foam Adapter Assembly AR3588 Inlet Hose Adapter complete AR1461470 Inlet Filter AR1340260 Lance Extension O-Ring AR391000 Foam Adapter O-Ring AR2000520 Hose Securing Clip AR2000080...
Need help?
Do you have a question about the JetKing 2000 and is the answer not in the manual?
Questions and answers