Teldat ATLAS 152 Installation Manual page 14

1 Installing the Router
• Turn off the device through the ON/OFF switch.
• Using a screwdriver, move micro-switch '5' to the ON position.
• Turn the device on with the ON/OFF switch.
When the device is switched on, a message similar to the one shown below will appear on the configuration console:
**************************************************
******************* Router Teldat ****************
**************************************************
BOOT CODE VERSION: 01.06
gzip Dec 28 2005 09:54:11
P.C.B.: A0
START FROM FLASH
BIOS CODE DUMP....................
BIOS DATA DUMP...
End of BIOS dump
Boot-stack used: 0x00000C38
Boot-stack free: 0x000013C8
===========================================================
BIOS TELDAT
===========================================================
BIOS CODE VERSION: 01.06
CLK=262144 KHz
Date: 01/12/06, Thursday
SDRAM size: 32 Megabytes
BANK 0: 32 Megabytes (detected)
Caches: ON
FLASH: 64 Mb.
NVRAM: 128 Kb.
EEPROM: 2048 Bytes.
DPRAM: 8192 Bytes.
ADSL2+
ISAC
RDSI_B
RDSI_B
SWITCH 10/100
SECURITY ENGINE
PCI device: Host bridge
(Bus: 0, Device: 0, Function: 0)
(Subs. Vendor: 0x0000, Subs. Device: 0x0000)
Current production date: 00 00
Current software license: 12 15
Current serial number: 550/05646
BIOS MAC Add: 00-a0-26-a0-16-0e
>>
........
TRYING APP CODE DUMP
(CONFIGURED) ATLAS2G.BIN ver.: 0.10.6.12 0.0.0.0........
...........................................................
...........................................................
...........................................................
...........................................................
...........................
APP DATA DUMP.............................................
10
Jan 2 2006 10:22:22
MASK:0C10 Microcode:00E1
BUSCLK=65536 KHz
Time: 12:40:13
Write-Back
(c)Teldat
PCICLK=65536 KHz L0
Teldat S.A.
ATLAS 152