Mounting System Components - Mounting Versions - BayWa novotegra closed II Mounting Instructions

Figure
4.2 Mounting system components – mounting versions
Figure
** Required components for ballast distribution at system edge, depending on substructure construction.
Subjects excepted. Illustrations are exemplary and may vary from the original.
V3.3 - April 2020/ASc,
Copyright BayWa r.e. Solar Energy Systems GmbH
Equipment Use for tool
Cordless Bit Torx TX 40
screwdriver Socket bit AF 8 mm
Torque key up
to at least Socket bit AF 8 mm
12 Nm
Chopsaw ---
Place / replace For place / replace of base foot and
tool base module supports set in the base
trough 150-30 trough 150-30
Tool Component**
Module support set 13° e/w
Material: Aluminium
Support brace 20x20x1.5
Material: Aluminium
Wind deflector 13° e/w
Material: Aluminium
Tool: Socket bit AF 8 mm
C-rail (base profile, base trough)
Material: Aluminium
Rail connector set
Material: Aluminium and stainless
steel
Tool: Special lock nut AF 18 deep
PE pad 140 x 390 x 20 mm
Material: PE foam
Application
Component
connections, clamp
assembly
Clamp assembly
Cutting rails
Correct installation
Product group
Module elevation
Profile rails
Module elevation
Profile rails
Profile rails
6