Table of Contents
Advertisement
MV 5 – Mounting 3rd base trough
1
MV 6 – Module supports east-west
MV 7 – Installing the module – system variant east-west II
Subjects excepted. Illustrations are exemplary and may vary from the original.
V3.3 - April 2020/ASc,
Copyright BayWa r.e. Solar Energy Systems GmbH
Depending on the ballast, a 3rd base trough may
be required for additional storage space. It should
be positioned centrally between two base troughs
according to the ballast plan. Secure the module
1
in addition to the clamps at the corners using the
flat roof end clamp on the long side (1).
The installation of a 3rd base trough may also be
necessary if the module support set or the base
foot is overloaded.
Secure the wind deflectors to the base troughs
with two screws for each base trough and to the
round part of the module support with one screw.
Regarding the occurring loads the module support
set of the east-west II system variant must be
installed with a single or a double leg.
Prior to installation, the position (installation axis)
of the components must be determined on the
base trough.
Depending on the conditions on site, it's
recommended to use the mounting and removal
tool.
Place the module landscape on base feet and
then put it on the module support set. Install the
modules of one axis of a double row first.
Place the required ballast in accordance to the
ballast planning inside or on top of the base
troughs after installing the modules.
After fixing the modules place the support brace
on the module support set and fit them together
with one screw each. Support brace joint
overlapping above the module support brace.
Place ballast and install the modules on the other
side of the double row on the module support set.
Wire adjacent modules when installing them.
Install the string cable first.
13
Advertisement
Table of Contents
