BayWa novotegra closed II Mounting Instructions page 16

MV 8 – Wind deflector east-west II
1
MV 9 – Ballast troughs
10 kg
35 kg
MV 10 – Installation of the coupling
profiles for ballast reduction
Subjects excepted. Illustrations are exemplary and may vary from the original.
V3.3 - April 2020/ASc,
Copyright BayWa r.e. Solar Energy Systems GmbH
Support wind deflector to module (1):
Place wind deflector under module, fasten module
and wind deflector with module fastener E-K on
support and with two further screws on the base
2
trough.
Support wind deflector to wind deflector or edge
(2):
Mount the east-west wind deflector on the module
support set 2S as described in the section
Mounting the wind deflector, on the base trough
with two screws and on the module support with
one screw.
Place the weight of the replaced module with
ballast stones into the east-west wind deflector.
10 kg
35kg
Using ballast troughs allows small and large
ballast which can be securely inserted or laid on if
required. The ballast troughs must be mounted
sideways to the base troughs.
Connect parallel module fields with two coupling
profiles. Secure the first profile (1) with two screws
on the left base trough and then secure the
second profile (2) on the right base trough. Leave
3
the loose end of the coupling profile protruding
1
over the edge of the second base trough (3).
2
The coupling profile is only firmly secured to one
base trough.
Distance between base troughs 50 mm.
14