Screwing On The Telescopic Lance And The Modular Pole - Cleantecs SOLA-TECS C Series Operating Instructions Manual

Screwing on the telescopic lance
Screwing on the modular pole
BA 0303788 R00 2019-03
Screwing on the telescopic lance
and the modular pole
� Screw the quick connector
the connection PIN
clockwise. Make sure that the connec-
tion PIN will slide when screwing it on.
� Screw on until the Sola-Tecs C
firmly attached.
� Tighten the quick-release screw
connection hand-tight.
CAUTION
Risk of injury due to incorrect
installation of the joints
�AAlways hand-tighten and check the
connection points.
This will protect you from being injured
by connecting parts ying around
uncontrollably.
NOTICE
Preventing damage to the quick
connector
�ATighten the quick-release screw
connection hand-tight. Do not use any
tools (pliers etc.) for tightening.
This will prevent chipping of the plastic
and damage to the thread.
Commissioning
[5] onto
[3] by turning it
[1] is
27