Intended Use; Requirements For The Photovoltaic Surfaces To Be Cleaned; Requirements For The System User; Space Requirement For The Sola-Tecs C - Cleantecs SOLA-TECS C Series Operating Instructions Manual

Intended Use

The Sola-Tecs C system is designed
for cleaning photovoltaic modules in
the commercial sector. A high-pressure
cleaner is required to drive the Sola-
Tecs C. A lance with a suitable connec-
tion is required to guide the Sola-Tecs C
system. The Sola-Tecs C system is de-
signed to remove dirt from photovoltaic
modules. It also washes the detached
dirt off the photovoltaic module.
Requirements for the photovol-
taic surfaces to be cleaned
The photovoltaic modules to be cleaned
must be firmly mounted on a mounting
frame. The photovoltaic modules must
be accessible without danger. The
working area must be free of electrical
hazards.

Requirements for the system user

User: The user must be instructed by
the operator on the assigned tasks and
possible dangers in case of improper
behaviour. The user may only carry out
tasks that go beyond normal operation
if this is indicated in this manual and
the operator has expressly instructed
them to do so.
Qualified personnel: Due to their techni-
cal training, knowledge and experience
as well as knowledge of the relevant
standards and regulations, qualified
BA 0303788 R00 2019-03
personnel are able to carry out the work
assigned to them and to independently
recognise possible dangers and avoid
risks.
The following groups of people are not
allowed to operate the Sola-Tecs C:
� Persons with limited physical, sensory
or mental abilities.
� Children and young people under 18
years of age
� Persons who have not been trained
Space requirement for the
Sola-Tecs C
� The Sola-Tecs C requires a support
surface of 0.16 metres x 1.0 metre.
� When cleaning, you need 5 m² of
space around the user.
� There must be at least 1 m distance
to the next obstacle in the working
direction.
� To prevent accidents, a safety area
of 20 metres around the user must be
closed against access by others.
Requirements for the high
pressure cleaner
� The high-pressure cleaner must gua-
rantee an operating pressure of 100-120
bar and a flow rate of at least 10 litres
per minute.
Basics
13