Setting Definitions - Assa Abloy Yale Assure Lock SL Installation And Programming Instructions

Setting Definitions
Settings
Master Entry Code
All Code Lockout
Auto Re-lock
Inside Indicator Light
Language
One Touch Locking
Privacy Button
Shutdown Time
Volume
Wrong Code
Entry Limit
*The Master Entry Code must be created prior to any other programming of the lock.
Default Setting
The Master Entry Code is used for programming
and feature settings. It must be created prior to
Creation
required*
programming the lock. The Master Entry Code will also
operate (unlock/lock) the lock.
This feature is enabled by the Master Entry Code.
When enabled, it restricts all Entry Code access
Disabled (except Master). When attempting to enter a
code while the lock is in All Code Lockout, the RED
locked padlock will appear on the screen.
After a successful code entry or manual unlock
with the key, the lock will automatically re-lock after
each unlock in an effort to keep your home secure.
Disabled
This feature is optional, and can be turned off.
When enabled, the lock will automatically re-lock
after thirty (30) seconds.
Located on the inside lock. Shows active status
Disabled (Off)
(Locked) of lock and can be enabled or disabled in
Advanced Lock Settings (Main Menu selection #3).
Choosing English (1), Spanish (2) or French (3)
English
becomes the (default) setting for the lock voice
prompts.
When the latch is retracted, activating the keypad
will extend the latch (during Auto Re-lock duration
or when Auto Re-lock is disabled). When One-Touch
Enabled
Re-lock is not in use (disabled), any valid Entry Code
will re-lock the lock.
Privacy mode is disabled by default. When enabled,
activate Privacy mode by pressing the privacy button for
Disabled
4 seconds to put the lock in do-not-disturb mode (all
Entry Codes are disabled).
The lock will shutdown (flashing RED) for sixty
(60) seconds and not allow operation after the
60 Seconds
wrong code entry limit (5 attempts) has been met.
The volume setting for Entry Code verification is set
Enabled (Low)
to Low (2) by default; otherwise it can be set to
High (1) or Silent (3) for quiet areas.
After five (5) unsuccessful attempts at entering a
5 Times valid Entry Code, the lock will shut down and not
allow operation for sixty (60) seconds.
18
P/N YRD256-MNL-0003 Rev G
Definition