Thermo Scientific Multifuge X1R Instruction Manual page 27

SAMPLE
When SAMPLE is lit, the temperature of the sample will be controlled.
To set the temperature, proceed as follows:
1. Press the key
The display shows the messages Temperature. Depending on the display mode setting, the value
shown corresponds either to the sample temperature or to the inside chamber temperature. Press
the
2. Enter the desired temperature using the numeric pad.
The digits show in sequential order.
3. Confirm your entry by pressing
Your entry will be automatically confirmed if you do not press any key for 5 seconds.
Prewarming or precooling the centrifuge
For setting the pretemp value for the centrifuge proceed as follows:
1. Hold down the
The display shows the message
2. Enter the desired temperature using the numeric pad.
The digits show in sequential order.
3. Confirm your entry by pressing
Your entry will be automatically confirmed if you do not press any key for 5 seconds.
4. The display shows:
Thermo Scientific
in order to open the temperature selection menu.
key to toggle between the two modes.
key for a minimum of three seconds to open the temperature selection menu.
Set
.
PreTemp.
.
4
Operation
Entering parameters
Multifuge X1R
4-7