Ricoh ST23 Service Manual page 30

6 March 1992
[C]
[I]
[L]
[J]
8. Remove the rear cover of the 1st sorter (6 screws).
9. Remove the lower right cover [A] (2 screws), motor cover [B] (2 screws),
and 2 studs [C] from the 1st sorter. Install them on the 2nd sorter.
10. Hook the spring [D] of the relay gate solenoid [E] packed with the 2nd
sorter to the relay gate lever [F] and fix the relay gate solenoid (2 screws
with washer and 1 connector).
11. Set the interface board [G] packed with the 2nd sorter on the CN200 of
the 1st sorter main board [H] so that the notch of the interface board is up.
12. Remove the front harness cover [I] (3 screws) and inner harness cover [J]
(2 screws). Connect the optical fiber cable [K] packed with the 2nd sorter
to the interface board and run the cable as shown in the illustration.
13. Install the relay connector [L] packed with the 2nd sorter to the end of the
optical fiber cable [K].
14. Reinstall the inner harness cover [J].
[B]
[H]
[G]
29
INSTALLATION PROCEDURE
[A]
[K]
[F]
[D]
[E]