Ricoh ST23 Service Manual page 29

INSTALLATION PROCEDURE
[I]
[H]
CAUTION: Unplug the copier power cord before starting the following
procedure.
1. Remove the strip of filament tape [A] fixing the relay unit cover [B].
2. Remove the strips of filament tape [C] and remove the cushions [D]
protecting the bins.
3. Open the front door [E], remove the strips of filament tape [F] fixing the
jogger unit and the grip unit.
4. Remove the screw [G] fixing the staple unit.
5. Remove the rear cover [H] (6 screws).
6. Remove the three brackets [I] supporting the vertical transport cover (2
screws each).
7. Remove the bracket [J] with the cushion supporting the bins (1 screw).
[B]
[A]
[F]
[E]
[F]
[G]
28
[C]
[C]
[J]
6 March 1992
[D]
[I]