Options Setting - LIFE home integration CT2 24 UNI DL Instructions And Warnings For Installation, Use And Maintenance

4 REGOLATIONS AND OPTIONS

OPTIONS SETTING

4.1 AUTOMATIC CLOSURE
An automatic closure is activated after a set PAUSE TIME.
Automatic reclosure is activated after a preset PAUSE TIME.
4.2 AUTOMATIC CLOSURE
By pressing and
values for the PAUSE TIME
Wait 20" or press the
in order to anticipate the exit from programming mode.
Work cycle:
OPEN - PAUSE - CLOSE - PAUSE
4.3 SLOWDOWN TIME ADJUSTMENT ADJUSTMENT TIME OF DECELERATION
5"
Wait 20" or press the
in order to anticipate the exit from programming mode.
ATTENTION:
The deceleration CAN'T be completely eliminated , in this phase the limit switch's push force will determine
The slowdown can NOT be completely eliminated, in this phase the thrust in the limit switch determines the stop of
the motor stroke.
the Stop in the motor's run.
8
1
+
you can set the various
button again
1
button again
a) Press the
- If none of the leds
automatic closure is not active , press the
button to activate it .
- If at least one of the leds
the automatic closure is activated, in order to
2
deactivate it press the
Leds are off.
LEDS ON
a) Press the
light up:
right will turn on:
By pressing
of he DECELERATION TIME the SLOWDOWN TIME
2
LEDS ON
button the green right Led turns on
+
is turned on the
button untill all of the
PAUSE TIME
AUTOMATIC RE-CLOSURE IS NOT
+
CHIUSURA NON ATTIVA
ENABLED
+
5 s
+
10 s
30 s
+
60 s
+
+
120 s
for 5" the Led green and red on the
the green and red LEDs on the right
+
and you can adjust the value
DECELERATION TIME
+
MINIMUM
+
+
+
DEFAULT
+
+
MAXIMUM
+
+ is on