Remote Learning - LIFE home integration CT2 24 UNI DL Instructions And Warnings For Installation, Use And Maintenance

3 REMOTE GESTION
REMOTE CONTROL MANAGEMENT
The control unit is fitted with a built-in radio receiver with a 750 code memory and 2 channels with a
The control unit is equipped with an integrated radio receiver with 750 code memory, on a frequency of
433.92 MHz frequency with LIFE Rolling Code and Auto code encoding.
433.92 MHz with LIFE Rolling Code and Auto-Code coding
3.1

REMOTE LEARNING

1
Wait for 20" or press the
Wait 20 "or press again the key fob selection button to
to anticipate the exit from the programmation mode.
quit the setup mode.
3.2 Removing an already existing remote setting
REMOVE AN EXISTING REMOTE TRANSMITTER
1
3.3 Deleting all of the remotes settings
REMOVE ALL EXISTING REMOTE TRANSMITTERS
1
2
button again
2
2
TOTAL OPENING
- Press the key fob selection button (top left); the left green LED
under "–" symbol and the first red dot (A) beside "– "symbol, will
a) Press the
light up.
[A] Led will turn on.
- Hold down the P1 button on the transmitter that you want to
pair to perform a total opening until all five LEDS light up.
b) Keep the button P1 of the radio control pressed until
all five LEDs light up
PEDESTRIAN OPENING LEAF N.1
SHTTER N°1 PEDESTRIAN OPENING
- Press the key fob selection button (top left) twice; the left
green LED under "–" symbol and the second red dot (B)
a) Press twice the
beside "– "symbol, will light up.
and the [B] Led will turn on
- Hold down the button on the transmitter that you want to
b) Hold down the P2 button of the radio control until
pair to perform a partial opening until all five LEDS light up.
all five LEDs light up
- Press and hold the key fob selection button for 5 seconds
a) Press the button for 5" , the left green led
until the left green light under "–" symbol comes on and
will firstly turn on and then will start blinking.
then starts blinking.
- Hold down the button on the transmitter that you want to
remove until all five LED's light up.
b) Keep on pressing the remote button until all of the
five Leds will light up
setting will be deleted.
- Press and hold the key fob selection button for 5 seconds
a) Press the
until the left green light under "–" symbol comes on and then
starts blinking. led will turn on and then start blinking.
- Press and hold the key fob selection button down again for
5 seconds and the LED's will blink alternately.
b) Push for 5" the
alternately
- As soon as the flashing stops, all remotes will be
uccessfully deleted.
As soon as the Leds will stop blinking all
of the remotes settings will be deleted.
button the left green Led and the
+ +
button and the left green led
+ +
+ +
the remote
button for 5" , the left green
button and the leds will blink
+
+
7