LIFE home integration CT2 24 UNI DL Instructions And Warnings For Installation, Use And Maintenance page 11

7 MANUAL PROGRAMMING
7.1 CLOSING LIMIT SWITCH LEARNING CLOSING FINISHES LEARNING
LEARNING OF THE CLOSURE LIMIT SWITCH
1
1
7.2 OPENING AND CLOSING PHASE SHIFT LEARNING LEARNING OFFSET AND FINISHES
LEARNING OF OPENING PHASE LAG AND LIMIT SWITCH OPENING PHASE SHIFT AND LIMIT SWITCHES LEARNING
1
1
1
CLOSING PHASE SHIFT LEARNING
7.3 LEARNING CLOSING OFFSET
LEARNING OF CLOSING PHASE LAG
1
1
1
Manual programming can be done with a button connected
Manual programming can be done with a button
to terminals 6 - 10 (Step-by-Step) or with the previously
connected to terminals 6 - 10 (Step-by-Step) or with
memorized radio control, page 7 chap. 3.1.
radio control previously memorized, page 7 cap.3.1.
Place the motors (leaves) at 45 °.
Position the motors at 45 °.
Hold the START button for 5 seconds, the 5 LEDs first light
START
Press
up and then flash.
start blinking.
During the flashing of the 5 LEDs give a command of
While the 5 LEDs are flashing, give a Step-by-Step
2
Step by step the leaf [2] must move first in closing,
command; the leaf [2] must move first performing a closure;
when he arrives at the stop he has to stop and the Led of the
when it reaches the mechanical stop it must stop and the
Right goes on with fixed red light.
Right LED lights up with a red steady light.
Give a second Step-by-Step command the leaf [1] must
Give a second step-by-step command; the leaf [1] must
2
move in closing, when it comes in batting it must stop and
perform a closure, when it reaches the mechanical stop it
the Left LED lights up with a fixed red light.
must stop and the Left LED lights up with a red steady light.
Give a Step-by-Step command the leaf [1] opens, al
2
reaching the point where you want to open also
Give a Step-by-Step command; the leaf [1] starts opening; as
the leaf [2] give a further step-by-step command.
soon as it reaches the point where you want to start opening
The two wings now proceed in opening until they reach the
leaf [2] give a further Step-by-Step command.
respective mechanical stops, the two red LEDs of left and
2
The two leaves now proceed to open until they reach their
right they remain in red light.
respective mechanical stops, the two red LEDs on the left
and on the right remain with a steady red light.
2
Give a Step-by-Step command the leaf [2] closes, al
2
Give a Step-by-Step command; the leaf [2] starts closing; as soon as
reaching the point where you want to close also
it reaches the point where you want to start closing leaf [1] give a
the leaf [1] give a further step-by-step command.
further Step-by-Step command.
The two doors proceed now in closing until they reach the The two leaves now proceed to close until they reach their
respective mechanical stops, the two red LEDs on the left and on
respective mechanical stops, the two red LEDs of left and
the right remain with a steady red light.
2 right they remain in red light.
Automation is now programmed in semi-automatic mode.
The automation is now programmed in semi-automatic mode.
If the result obtained is not satisfactory, carry out the
If the result obtained is not satisfactory, perform the
reset the control unit and start again from point 7.
2
reset the control panel and restart from point 7.
for 5 seconds , the 5 leds will light up and then
11