Configuring The Hub Monitor Ip; Dynamic Ip - Samsung C23A750X User Manual

2
Using "HUB Monitor"
This is achieved by an internal chip that transmits data received via the LAN cable to the PC as a
converted USB signal.
Connecting to a LAN via Wireless USB
LAN
Connecting to a LAN via USB cable
LAN
This product cannot connect to multiple source PCs at the same time and vice versa.
2.5

Configuring the HUB Monitor IP

1
After installing the integrated driver for HUB Monitors, go to Control Panel
Network and Sharing Center
→
2
You can see that the following two devices are displayed.
a. The user PC's network device
b. The HUB Monitor's network device (USB to Ethernet adapter)
The two devices above refer to your PC's LAN network device and your HUB Monitor's network
device.
To use the Internet using the HUB Monitor's LAN network, configure the network settings as follows
according to the type of IP you will be using.

2.5.1 Dynamic IP

The dynamic IP address mode automatically configures the network settings on the PC using data sent
by a server, which allots an IP address. This is possible, owing to the "DHCP (Dynamic Host
Configuration Protocol)" service. The service consists of three steps: an IP address allotment request is
sent to the DHCP server when the PC boots up, the DHCP server that received the request transmits
USB CABLE
Change adapter settings.
→
Network and Internet
→
2 Using "HUB Monitor"
36