Configuring The Touchscreen Monitor Settings; Calibration - Samsung QBC User Manual

Configuring the touchscreen monitor settings

To properly use the touch function of the product in Windows, go to Tablet PC Settings and calibrate the product.
" First connect the touchscreen monitor before configuring the following settings.
" The maximum number of touchscreen monitors that can be connected simultaneously varies, depending on the operating system and graphics card settings.
" If Tablet PC Settings is not found in Control Panel, search for Tablet PC Settings from Search Control Panel.
" If used in a multi-screen setup, make sure you have configured QB24C-T as the main display.

Calibration

" Instructions below are for Windows 8. The same method applies to both Windows 7,
Windows 8 and Windows 10.
" After changing the Picture Size from the OSD menu, you may need to calibrate the picture
settings again.
" Upon occurrence of an error during calibration, go to Tablet PC Settings. In the Display tab,
tap Reset and calibrate again.
1
In the Display tab, select Setup under Configure.
2
Tap the page displayed on the product with your finger.
" In dual monitor mode: If the following page does not appear on the product, press the
Enter key to display the page.
Touch this screen to identity it as the touchscreen.
If this is not the Tablet PC screen, press Enter to move to the next screen. To close the tool, press Esc.
36