Half Load; Delayed Start; Starting The Dishwashing Programme - Hanseatic HGU4582D10J7710EI User Manual

Page EN-24 Dishwasher operation

Half load

(13)
Select the "Half load" option if you would like
to run the appliance with less than 6 place
settings. This additional option reduces water
and power consumption.
The "Half load" option is not available with
programmes and
• The "Half load" option can be
– activated by pressing the ½ (4) button
The ½ (13) indicator will appear on the
display.
– deactivate the option, press the button
again. The indicator will disappear from
the display.

Delayed start

(2)
The wash cycle normally starts as soon as
you press the 'Start/Pause' button
If you want the cycle to begin later, you can
specify this. The start time can be delayed
between 1 and 24 hours.
• Press the button (2) as many times as
necessary for the display (8) to show the
delay required ( ,
H: 0 0
(4)
.
(8)
(6).
to ).
H: 0 1 H: 2 4
Starting the dishwashing
programme
(1)
(8)
(16)
1. Start the programme with the button
If you
– have not set up a start delay, the pro-
gramme cycle will begin after a few sec-
onds.
– have set up a delayed start, the display
will initially still show the start-delay du-
ration (8); the dots between
number of hours will flash. After the start
delay runs out, the programme will start.
During the programme the display will
show the time remaining (16); the dots be-
tween hour and minute numbers will flash.
At the end of the programme cycle,
an acoustic signal will sound 8 times and
the display will show
end
2. Switch the dishwasher off using the
button (1).
3. Turn the tap off.
4. Wait a little while before unloading the
dishwasher.
If no further settings are made, the appliance
will automatically switch off/enter standby
mode after 15 minutes.
(6)
(6).
and the
H
.