Hanseatic HGU4582D10J7710EI User Manual page 80

Page EN-38 First use
Problem
3 The control display for
the dishwasher salt
is displayed although
dishwasher salt has
been refilled.
4 The water is not
running or it is running
only very slowly.
5 The water is not
running off or only very
slowly.
6 The dishwasher is not
watertight.
7 There are residues or
streaks on the dishes.
8 The dishwasher can
be switched on/off,
but not cannot be op-
erated.
9 The dishes are not
completely clean.
Possible cause
The dishwasher salt is
clumpy.
There is a kink in the inlet
hose.
The water tap is not
properly on.
The filters are blocked.
The outlet hose is kinked,
has been extended or is
hanging too high up/too
low.
The door seal is defec-
tive.
The outlet hose or the
inlet hose is defective.
The rinse aid is incorrectly
dosed.
There is no dishwasher
salt.
The dishwasher salt is
clumpy.
The dishwasher can only
be operated when the
door is closed.
There are food scraps
which are encrusted onto
the dishes.
The dishes have not been
stacked optimally.
You have selected the in-
correct programme.
The dishwasher detergent
is incorrectly dosed.
The water pressure is too
low.
The spraying arm can not
rotate unhindered.
The nozzles on the spray-
ing arm are blocked/
calcified.
Solution
Stir the dishwasher salt using the end of a
spoon or similar.
Lay out the inlet hose in such a manner that it
is not kinked.
Turn the water tap on completely.
Clean the filters (see„Checking and cleaning
the filters" on page EN-27).
Lay out the outlet hose in the proper manner
(see„Having the outlet hose connected" on
page EN-29).
Have the door seal replaced (see„Service" on
page EN-40).
Have the defective hose replaced
(see„Service" on page EN-40).
Adjust the dispensed dose (see„Changing the
rinse aid dose" on page EN-15).
Add dishwasher salt (see„Adding dishwasher
salt" on page EN-16).
Stir the dishwasher salt using the end of a
spoon or similar.
Close the door.
Soak dirty dishes prior to washing the dishes.
Stack the dishes in such a way that all parts
can be reached by the water jets (see„Loading
the dishwasher" on page EN-17).
Select the correct programme using the
programme table (see„Programme table" on
page EN-21).
Dose the dishwasher detergent according to
the programme table (see„Programme table"
on page EN-21), the packaging information and
your degree of water hardness.
Turn the water tap on completely.
Ensure that no dishes are impeding the mo-
tion of the spraying arm.
Clean the nozzles (see„Checking and clean-
ing the spraying arms" on page EN-28).