Table of Contents
Advertisement
Assembling of
Cord for Motor and Cord for Brake
<
Assemble Front cover while Battery changeover
switch is come out of Center case.
Don't route Lead wire of
Cord for Motor (with
Connector) in the area as
shown below.
Root of Controller
lead wire ( Signal
wire connecting to
Motor and Brake)
Strain relief
Route Controller
Lead wires connected
to Cord for Motor and
Connector of Cord for
Brake between Ribs.
Put Connector of Cord for Brake in the
space as shown above.
>
Tip of Sheath of Cord for Motor should not be jumped out from root
of Controller lead wire (Signal wire connecting to Motor and Brake)
Battery changeover switch
Rib
Put Closed end splice connected to Lead
wire of Cord for Motor in the space.
Put Controller lead wire connected to
Connector in these grooves.
30 / 41
Route Lead wire of Cord for Motor (with
Connector) between Boss and inner wall.
Boss
Put Connector of Cord for Motor in
the space as shown below.
Cord for Motor
Put Controller lead wire connecting
to Cord for Motor (with Connector)
in the space.
Cord for Brake
Put Line filter passed through
Controller lead wire connecting to
Cord for Brake in the space.
Advertisement
Table of Contents
