Table of Contents
Advertisement
Fig. 30
[4]
[5]
[3]
5
After adjusting the Brake switch on the motor to check the following parts for proper function.
・When you pull a Brake lever, brake works effectively before you pull half of the Lever.
・When you don't pull a Brake lever, the Wheelbarrow moves ahead with/ without battery power, without generating
noise nor resistance etc.
・When you pull a Brake lever while Switch lever is being pulled, Motor stops.
6-7
Front tire, Wheel (Motor)
6-7-1
Disassembling
*If you repair Front tire assembly you can start from Fig.35 (next page).
1
Remove Brake caliper according to 6-6 (P12) to prevent from interference of Brake disc and Brake shoe at
assembling procedure.
2
Open Front cover according to 6-3 (P6) and then remove Strain relief connected to Motor and Connector. Then
cut three Closed end splices.
Fig. 31
[1]
Fig. 31
[1]
[1]
1R36
[2]
[1]
[2]
[2]
[3]
[5]
[2]
[4]
3
Temporary fasten Brake caliper with M6x18 H.S.H bolts
W/ WR [1].
4
Inserting 1R366 (0.1mm) between Brake disc [2] and
Brake pad [3] support Lever [3] to apply Brake effectively.
Eliminating the sagging of Brake cable, fasten Hex socket
bolts [1] (2 pcs) and then a Hex socket bolt [5] to fix Brake
cable.
3
Remove Cord by cutting Band[1] with a nipper. Inside part
of Band falls into Frame when it is cut off. But it is no
problem.
Band [1] should be replaced every time when the machine is
repaired.
4
Turn the machine upside-down and put Lower frame [1] on
a support stand or conntainer box. Then Front tire is seen
just before your eyes.
5
Remove M16-24 Hex nuts (2 pcs, left/right of Wheel[3] )
[4], and Flat washer 17 [5] (2 pcs) with an Impact driver
attached Socket 24 [2].
14 / 41
Note
Advertisement
Table of Contents
