8-1-3
Assembling of other than Power supply cord
Fig.:Drawing after repair
<Area A>
<Assembling of Area A>
Lead unit (for connecting to Key)
Put Electrolytic capacitor
in this space.
Electrolytic capacitor
Put Closed end splice connected
to Lead unit
(for connecting to Key)
in this space.
Cover
Don't put
any Lead wires
on this
Rib.
24 / 41
<Area B>
Put Lead wires in the below area
・between Cover and Lead unit (for connecting Key)
・between Cover and Center case
Put Controller lead wire connected to Electrolytic capacitor and
Lead unit
(for connecting to Key) one of Lead holder one by one.
Lead wire must be tight in Controller side. Don't make a slack
around Lead holder.
to avoid pinching.