Table of Contents
Advertisement
・
Tape A , Tape B: Sub controller complete (without Switch) for bundling Lead wire
Put Tape B in left or right groove as shown below.
Don't put any Lead wires on this Rib.
Sub controller complete (with Switch)
Cover
Don't put
any Lead wires on this
Cover.
Put two Connectors Sub controller complete (both with Switch
and without Switch) in this space as shown above.
Lead wires of
Sub controller complete (without Switch)
must be tight. Don't make a slack between Tape A and Tape B.
Lead wire connected to Sub controller complete (without
Switch) between Boss and Rib A.
Put Tape A in
Rib A
Tape A
Tape B
Boss
Don't route
controller complete (without Switch).
26 / 41
this space.
Sub controller complete
(without Switch)
any Lead wires under
Sub
Advertisement
Table of Contents
