Table of Contents
Advertisement
Fig. 46
Wood stand
Fig. 347
[1]
[2]
Fig. 48
[1]
Fig. 49
[1]
[2]
Fig. 50
[2]
[3]
[1]
11
Prepare some wood stand to put Wheel.( only Wheel to turn
Front tire) Put the wiring side of Wheel upward.
12
Engage bead of Front tire 430 and Wheel by pushing down
the tire. And then pump up to be engaged completely.
13
Insert Valve core with Valve clip [1] to prevent from air
leakage out of Front tire.
Adjust air pressure to designated 0.23Mpa with Air gauge
[2] .
14
Check air leakage by applying soap water to beads area [1]
of the tire and Snap in valve [2].
[2]
Don't put Wheel engaged with the Tire into water to avoid
immersion of Motor.
If there is an air leakage, bubble comes out. Or film forms
and then it breaks.
15
Tighten Cap [2] with Snap in valve [1] by hand.
16
Assemble by reversing 6-7-1 Disassembling procedure.
・Assemble Brake disc [2] with the face without printing
・Insert six Flat washers between Brake disc [2] and
Wheel and then tighten them with Hex socket head
bolts (6 pcs).
19 / 41
Note
Note
Tips
Note
Advertisement
Table of Contents
