Table of Contents
Advertisement
6-5
LED light
6-5-1
Disassembling
Fig. 16
[2]
Fig. 17
[4] [5]
[3]
[6] [7]
[2]
Fig. 18
[3]
[4]
[2]
Fig. 19
[1]
[2]
[2]
[1]
[1]
[2]
[2]
[1]
1
(In case of replacing only LED lights)
Remove only inside Bind PT 3x16 Tapping screws [2] (2
pcs). Then LED light assembly [1] can be disassembled.
2
Remove CT 4x16 Tapping screws [1] (4pcs) and remove
Light case cover [2] (Left/ right both Lights)
Put some board on the center Lower frame to make a
workbench.
3
Remove Cover [3] turning left by hand and then remove
Lenz [5], Reflector [6], O ring 53 [7]. If you remove Cover,
O ring [4] is removed together.
4
Remove CT 4x16 Tapping screws [1] (4pcs) and remove
Strain relief [2], and pull off Connector [3] to dismantle
LED circuit.
*The left Fig. is right side LED light.
5
If you repair Guard R/L [1], remove M5x16 H.S.H. bolt [2]
(2 pcs). (Outside two bolts among total four bolts.)
10 / 41
Tips
Advertisement
Table of Contents
