Bartscher KV1 Smart Manual page 26

Cleaning the dregs container and drip tray
,
Cleaning the water tank
1. Remove the water tank.
2. Wash the water tank thoroughly each
EN
time it is filled with water.
3. Then, fill the water tank with fresh
potable water and reinstall it in the
appliance.
4. The water tank should always be
removed very carefully; never let it fall.
Should the water tank get damaged, it
must be replaced immediately.
24 / 32
After preparation of 15 cups of beverages, the display will show
the 'empty tray' message.
1. When you remove the dregs container and the drip tray, you
may empty and clean both containers.
2. Clean them with warm water and gentle washing agent.
When both containers are re-installed, the 'ready' message will
be shown on the display.
When the dregs container is full, the display will show the
'Empty tray' message.
When the dregs container is reinstalled, the 'ready' message will
be shown on the display.
Cleaning and Descaling
190069