Table of Contents
Advertisement
CHIMNEY AND FITTING JOINT ASSEMBLY (DS-DSD-DSID)
(See Page 21 for DSLS-DSLD)
All components have a male and female end, the male end has the gasket.
The installation orientation is indicated on the labeling of each chimney
section with an arrow. The arrow indicated the direction of the flow.
Secure Seal ® DS
1. Add a thin film of
silicone lubricant on
the o-ring.
2. Insert the male end
into the female end.
3. Close the clips to
secure
the joint.
NOTE:
Clips are self-locking
Figure 7 - Joint assembly steps
To open clips, push the secondary catch while pulling up the lever
Push
Pull Up
Figure 8 - Opening clips
12
Secure Seal DSD / DSID
Bead
ASSEMBLY JOINT DS/DSD/DSID LUBE REQUIREMENT
Inside Diameter
3"
4"
5"
6"
7"
8"
9"
10"
12"
14"
16"
18"
20"
22"
24"
Table 12
*Important Notes: ( DS-DSD-DSID ONLY)
1. For Anchor Plate (AP) / Anchor Plate Heavy Duty (APHD) / Wall Support
Heavy Duty (WSHD), the support must be installed below a bead. See
Figure 9.
2. For Wall Support (WS) / Roof Support (RS) , the support can be installed
anywhere on the part.
3. For Anchor plate length, the support is already integrated to a length.
Directly attached to the building structure or supported by non combustible
structural elements (not included). No other installation is required than
the standard installation for a regular length.
Anchor plate,
Anchor plate HD
or Wall support HD
1. Pass the female end through the hole of
the one part plate.
2. Install the two parts plate below a bead
and bolt it to the one part plate.
Figure 9 - Position of Support
Qty (oz)
0.1
0.1
0.1
0.1
0.1
0.2
0.2
0.2
0.3
0.3
0.3
0.4
0.4
0.5
0.5
Bead
One part plate
Two parts
plate
Bolts and
nuts
Advertisement
Table of Contents
