Maintenance Instructions; Warranty & Product Reference Information - DuraVent DuraSeal DS Installation Instructions Manual

Single wall or double wall al29-4c or 316l special gas vent for category i, ii, iii and iv type l vent low temperature venting system
Hide thumbs Also See for DuraSeal DS:
Table of Contents

Advertisement

NOTE: Maintain adequate spacing for expansion from the floor and
the outer band (BSE) that is under the floor.
NOTE: If the maximum freestanding duct height above the Ventilated
Anchor Plate(APV), Ventilated Anchor plate with length (APVL) or Full
Angle Ring (FAR) exceeds that shown in the Table 7 & 8, guying is
required.
Figure 65a - Minimum Opening for flat roof
° to
°
5
30
Figure 65b - Minimum Opening for sloped roof
Outer Band
(BSE)
Storm Collar
(SC)
Flashiing (F)
Floor
Figure 66 - Installation of Flashing- View Top of the Roof
Flat Roof
"x"
"x"
Duct Section
Exterior Sealant
(S375)
Outer Band
(BSE)
Duct Section

MAINTENANCE INSTRUCTIONS

As with all vents, the DuraSeal vent system should be inspected at least
an nually for the presence of deposits or debris and any accumulation
should be removed. The vent system should also be inspected at regular
periods for signs of leakage of condensate or combustion products at any
joints.
If the vent system incorporates a drain hose from either a Drain length or a
Drain tee cap, the hose must be inspected periodically to ensure that water
is in the trap loop. If a proper trap loop is not maintained, exhaust from the
connected appliances may accumulate in the building area.
WARRANTY
These products have a limited warranty. Please read the warranty to be
familiar with its coverage.
Retain this manual. File it with your other documents for future reference.
PRODUCT REFERENCE INFORMATION
Please contact DuraVent for the phone number
of your nearest DuraVent dealer who will answer
your questions or address your concerns.
Normally, all parts should be ordered through your DuraVent distributor or
dealer. Parts will be shipped at prevailing
prices at time of order.
When ordering repair parts, always give the following information:
1. The model number of the chimney system.
2. The part number.
3. The description of the part.
4. The quantity required.
5. The installation date of the chimney system.
If you encounter any problems or have any questions concerning the
installation or application of this system, please contact our dealer.
33

Advertisement

Table of Contents
loading

This manual is also suitable for:

Duraseal dsdDuraseal dsidDuraseal dslsDuraseal dsld

Table of Contents